Does anybody know the programing sequence for programing a keyless entry remote on a '99 4Runner?

 

I ran across directions to do this somewhere on the internet a while back and printed them off. I used them for my '99 4runner, and it worked for me. Lots of steps to follow, but read through them a couple of times, then give it a try.

Step 1 - open drivers side door and get in your vehicle.

Step 2 - put key completely into ignition,then pull out.

Step 3- with door open, lock and unlock 5 times on door console (ten clicks total).

Step 4 - close door then open door.

Step 5 - lock and unlock 5 times on door console (ten clicks total).

Step 6 - put key completely into ignition then turn to the on position then pull key out (you will now hear the door locks lock then unlock a couple of times)

Step 7 - now quickly press the lock and unlock buttons at the same time and hold for one second.

Step 8 - then quickly press and hold the lock button for two seconds.

Step 9 - exit car and close the door

After you do this you should hear a beep then your lights will flash. This will indicate that your remote is programmed to your vehicle. Good luck, and hope this works for you.

 

Anybody know how to program an 09 4 runner so you can use the wireless remote to lock/unlock truck while engine is running??

 

Be a bit more specific b/c it influences the answer ... which exactly is aftermarket? The remote start and the keyless entry? ... or just the remote start with the OEM keyless entry?